Main Applications; Cautions For Use; Air Pressure - Genio 050150 Manual De Instrucciones

User Manual EN
Important Information
Please read, understand and follow all safety information
contained in these instructions prior to the use of this tool. Retain
these instructions for future references.
Foreword
Genio is our brand for air tools. We have devoted all our efforts
in improving quality and tools' life. As well as the noise and
vibration of the tools. Bring all of you working efficiences, profits,
and enjoy using the tool is our principle.
Features
1. Finishing of flat wide surfaces.
2. It causes no dust for its accessory dust collector.
3. The grinding speed can be freely adjusted by raising or lowing
the lever according to the application.
4. Rear exhaust eliminates flying dust and noise.
Warning
1. This tool is not appropiate for coming into contact with electric
power source.
2. It is forbidden to use this tool in explosive atmospheres and do
not put any combustible material near the workpiece since it
emit sparks when it grinds with metal material.
3. Prevent long hair or loose clothing from drawing in while
operating this tool.
4. Never carry the tool by hose and beware of a whipping
compressed air hose.
5. Rotating action can cause this tool to become hot. Allow to
cool and disconnect air hose before any changing or adjusting
6. It is not designed for wax polish.
4
Operator's instruction

1. Main Applications

Durability, versatility and power make this highspeed sander
excellent for paint removal, shaping filler patches, weld
smoothing, and rust removal. Ability to precisely control speed
makes this tool useful for a variety of surface conditions and
contours.

2. Cautions for Use

2.1. Air pressure

Maximum performance is displayed at the proper sanding speed,
obtainable at a gauge pressure of 6.2 bar. Range-wise, this is an
air pressure from 5 to 7 bar (70 to 100 psi)
2.2. Air line
Use a 3/8" air hose between the compressor and the tool.
Compressed air is cooled and its water content separated as
soon as the air leaves the compressor. A portion of the water
content, however, is condensed in the piping, and can enter the
tool mechanism, and may cause trouble. So, install an air filter
and an oiler between the compressor and the tool. Use a 3 HP or
larger compressor for each sander.
2.3. Air hose
Clean the hose with a blast of compressed air before connecting
the hose to the air tool. This will prevent both, moisture and dust
within the hose from entering the tool and causing possible rust
or malfunction. To compensate for unusually long hose (over 25
ft), the line pressure should be increased accordingly.
5
7