Imetec F2015 Instrucciones De Uso página 19

TUMBLE DRYING
• The throw can be tumble dried on a wool programme, but at the end of the drying
cycle it must be laid out to let it dry completely.
• Tumble dry at a low temperature.
• Remove the throw from the drier at the end of the drying cycle and pull it back into
shape, and into its original size.
• Lay the throw flat on a clothes airer to allow it to dry completely.
HANGING THE THROW OUTSIDE TO DRY
• The throw must be stretched back to approximately its original size during the
drying process. This is best done whilst damp, working from side to side, stretching
a piece at a time. This procedure may need to be repeated a few times until fully
dry.
• DO NOT use the throw until it is completely dry.
WARNING! Dry the appliance flat without using pegs to
avoid damaging it. Leave it to dry, laid out flat on a clothes
airer, not in direct sunlight.
• DO NOT iron the throw.
WARNING! Examine the appliance against the light to
make sure the cables are not bent or twisted.
WARNING! If the appliance does not resume its original size or if
problems arise with the internal cables contact an authorised
service centre for a safety check.
When not in use, store as follows:
• Make sure your throw is dry if it has been washed.
• Fold your throw loosely being careful not bend the wires too forcefully
• It is recommeded to store the throw in the bag it was purchased in.
• When storing the appliance, allow it to cool down before folding.
• Store the throw in a dry place.
STORING THE THROW
EN
18