Noise Level - Ribimex Ribitech RBAT20/P Manual De Instrucciones Y Mantenimiento

(D) Special warnings when using the product
1. Become familiar with the controls and the proper use of the tool.
2. Keep children and bystanders away
Do not let bystanders touch the tool or its power cable or the extension cord.
All bystanders (esp. children) should be kept away from tool and work area.
Keep the product away from children or from their environment. Never allow children to operate the tool.
Children should be supervised to ensure that they do not play with the tool.
3. Only well-instructed adults should operate the product. This product is not intended for use by persons
(including children) with reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning use of the product by a person
responsible for their safety.
4. Within the working area, the person using the machine is responsible for any damage or injury sustained by
third parties or their property which has been caused by the machine. Watch your working area and do not
allow third persons or animals to be around.
5. Do not use the tool in wet or damp conditions, areas. Keep work area free from tipping hazards.
6. Never change the rotation direction of the chuck while the tool is still running. Ensure that the chuck has
come to a complete stop before changing rotation direction.
7. Never put down the tool unless the tool is switched off and the chuck has come to a complete stop.
8. Keep hands and other body parts well away from the workpiece while tool is in use.
Keep hands well away from the underside of the workpiece during use. Do not use your hands to remove
any dust, chips or other waste while the tool is in use. Do not touch the bit right after operation, as it may
be hot and cause burns.
9. When using tool for screwing/unscrewing, place the screw bit on the screw head only when power tool
is switched off.
10. Residual risks
Even when the tool is used as prescribed it is not possible to eliminate all residual risk factors. The following
hazards may arise in connection with the tool's construction and design:
a. Damage to lungs if an effective dust mask is not worn.
b. Damage to hearing if effective hearing protection is not worn.
c. Health defects resulting from vibration emission if the power tool is being used over longer period of time
or not adequately managed and properly maintained.

10.1. Noise level

Wear hearing protection while operating the power tool.
The measured values have been measured in accordance with a standard test method.
The measured values are mentioned in the characteristics table.
10.2. Vibrations level
The declared vibration total value has been measured in accordance with a standard test method and may be
used for comparing one tool with another.
The declared vibration total value may also be used in a preliminary assessment of exposure.
Warning! The vibration emission during actual use of the power tool can differ from the declared total value
depending on the ways in which the tool is used.
There is the need to identify safety measures to protect the operator that are based on an estimation of exposure
in the actual conditions of use (taking account of all parts of the operating cycle such as the times when the tool
is switched off and when it is running idle in addition to the trigger time).
10.3- Electromagnetic field
WARNING! This machine produces an electromagnetic field during operation. This field may under some
circumstances interfere with active or passive medical implants. To reduce the risk of serious or fatal injury,
we recommend persons with medical implants to consult their physician and the medical implant
manufacturer before operating this machine.
11. Remarks:
The safety precautions and instructions given in this manual are unable to cover in detail all the conditions and
situations that may arise.
Page 19 / 62