Ribimex Ribitech RBAT20/P Manual De Instrucciones Y Mantenimiento página 21

4.5- Inserting and removing a bit
Open chuck electrically or manually.
Insert the selected drill/driver bit into the chuck. Make sure that it is centered.
Rotate the chuck until the drill/driver is gripped.
Using even torque tighten the chuck.
4.6- Changing to Forward or Reverse mode (Fig.1)
To change the rotation, press on the Forward/Reverse selector (8).
Note: do not abruptly change rotating direction when machine is operating.
4.7- Torque setting (Fig.1)
To adjust the torque, rotate the selector (2) to desired level.
4.8- Speed selector (Fig.1)
Place the speed selector (3) on desired position:
- Low (low speed with high torque)
- High (high speed with low torque)
Remark: Ensure that product has come to a stop before proceeding to any adjustment.
V. OPERATION
5.1- Intended use
- The product is intended for domestic use (indoor or under shelter).
- The product is intended for drilling and forward/reverse screwing (within tool own specifications).
- Do not use tool for any other use outside the scope of this manual.
- The product is not intended for artisanal, commercial, professional and/or industrial use.
- Do not use for applications not covered in this manual.
- The manufacturer or seller cannot be held responsible for incorrect or non-compliant use of machine.
5.2- Operation:
1. Ensure that battery is fully charged.
2. Wear appropriate protective equipment.
3. Insert bit or accessory in the chuck.
4. Prepare material for work
5. Secure material if necessary.
Do not use your own weight or body to hold material.
6. Firmly hold tool to avoid kickbacks. Always maintain a balanced and secure position.
7. Place bit on material. Do not make sudden movements.
8. Press on switch (7) to start operation.
9. Once work is finished, stop product by releasing the switch (7).
Note: do not put down product until chuck has completely stopped rotating.
WARNING! Do not become careless in assuming your knowledge of the tool.
DO not be filled (over repeated use) with a sense of ease and familiarity with the tool, neglecting strict
compliance to the safety instructions given with the tool.
Improper us of the tool or failure to comply with the provided safety instructions in this manual can cause
severe injury.
Remember that a split second of negligence is enough to cause serious damage.
Stay alert for your surroundings and especially for any danger that you may not hear while using the tool.
Page 21 / 62