Genio 050973 Manual De Instrucciones página 18

Manual EN
4. PRODUCT SPECIFICATION AND OPERATING INSTRUCTIONS
Specification
Sander Type
Ø Orbit (mm)
Ø Pad Size (mm)
Free Speed R.P.M.
Motor Hp (W)
Mains Voltage
Measurement
Weight (Kgs)
Hose Connection
IMPORTANT NOTE:
stated in the table are from laboratory testing in
conformity with stated codes and standards and are
not sufficient risk evaluation for all exposure scenarios.
The actual exposure values and amount of risk or harm
experienced to an individual is unique to each situation
and depends upon the surrounding environment, the way
in which the individual works, the particular material
being worked, work station design, as well as upon the
exposure time and the physical condition of the user.
We cannot be held responsible for the consequences of
using declared values instead of actual exposure values
for any individual risk assessment.
OPERATING INSTRUCTIONS
PRIOR TO THE OPERATION
1. The tool is intended to be operated as a hand held
tool. It is always recommended that while using the
tool, operators stand on a solid floor, in a secure
position with a firm grip and footing. Be aware that
the sander can develop a torque reaction.
2. This tool is designed for fine finishing task, do not
force sander heavily like conventional electric sanders
or air sanders. Slightly sanding is the proper way in
use; it can be more efficiency than heavily sanding.
18
Central Vacuum
5(3/16) / 2,5 (3/32)
150(6)
2,000-10,000
350W Max.
220~240VAC
251*150*94 (mm)
0.9
Ø26.5mm
The noise and vibration values
OPERATING INSTRUCTIONS
1. Plug-in the sander's AC power cord to the power
source (220~240VAC output).
2. Press the power ON/OFF button "
plate to switch on the sander. The LED indicator
shows " Solid green " color after sander being
switched on.
3. Adjust the speed by pressing " + " or "— " buttons
on the button plate. Press " + " is to raise up to higher
speed setting, "— "is to lower the speed setting.
The LED indicator shows " flash red " color . The LED
light won't flash when the motor reach the maximum
& the minimum speed.
4. Press the lever to start the tool. Release the Lever to
stop the tool.
5. Press the power ON/OFF button "
plate to switch off the sander.
HIBERNATION
The security system can reduce the possibilities to
malfunction. If the tool standby over 3 mins, the security
system will execute immediately into Hibernation/ Off.
In the Hibernation mode, there won't be any lights on
the LED indicator. The sander needs to be restart.
ABNORMAL INDICATION
Malfunction happens when the LED flashes"red and
green" alternately. Please refer to the trouble shooting
instruction to solve the abnormities.
MAXIMUM SPEED FUNCTION
This Electric Random Orbital Sander has nine preset
Maximum Speeds (2,000-10,000 RPM.) The original
starting speed seting is not the maximum speed when
the tool was shipped out from the manufacturer.When
the Sander is started after the Power Supply is turned
"ON". The Maximum Speed can be changed at any time
while the Sander is running or when it is stopped and
", on the button
", on the button