Programming; To Add Or Reprogram A Hand-Held Remote Control; To Erase All Codes From Motor Unit Memory; 3-Function Remote Controls - Craftsman 139.53993DM Manual Del Propietário

PROGRAMMING

NOTICE: If this Security ✚
®
of the garage door opener, which provides security against code-theft devices, will be circumvented. The owner of the copyright in
the garage door opener does not authorize the purchaser or supplier of the non-rolling code transmitter to circumvent that technical
measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security✚
USING THE "LEARN" BUTTON
1. Press and release the "learn" button on the
motor unit. The learn indicator light will glow
steadily for 30 seconds.
2. Within 30 seconds, press and hold the
button on the hand-held remote control
that you wish to operate your garage door.
3. Release the button when the motor unit
lights blink. It has learned the code. If light
bulbs are not installed, two clicks will be
heard.

To Erase All Codes From Motor Unit Memory

To deactivate any unwanted remote control, fi rst erase all codes:
Press and hold the "learn" button on motor
unit until the learn indicator light goes out
(approximately 6 seconds). All previous codes
are now erased. Reprogram each remote
control or keyless entry you wish to use.
garage door opener is operated with a non-rolling code transmitter, the technical measure in the receiver

To Add or Reprogram a Hand-Held Remote Control

*
®
remote controls.
USING THE PREMIUM CONTROL CONSOLE
1. Press and hold the button on the hand-held
remote control * that you wish to operate
your garage door.
2. While holding the remote control button,
press and hold the LIGHT button on the
Premium Control Console.
3. Continue holding both buttons while you
press the push bar on the Premium Control
Console (all three buttons are held).
4. Release buttons when the motor unit lights
blink. It has learned the code. If light bulbs
are not installed, two clicks will be heard.

*3-Function Remote Controls

If provided with your garage door opener, the large button is
factory programmed to operate it. Additional buttons on any
®
Security✚ 3-Function remote
control or compact remote control
can be programmed to operate
®
other Security✚ garage door
openers.
35