Programming; To Add Or Refuograrn A Hand-Held Remote Cantml; To Erase All Codes - Craftsman 139.53910 Manual Del Propietário

programming

NOTICE: If this Securityi^garage door opener is operated with a non-roiling code transmitter, the technical
measure in the receiver of the garage door opener, which provides security against code-theft devices, will be
circumvented. The owner of the copyright in the garage door opener does not authorize the purchaser or
supplier of the non-rolling code transmitter to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand^heid remote
control. The door will open and close when you press the large push button. V >
Below are instructions for programming your opener to operate with additional Security+® remote controls.

To Add or Refuograrn a Hand-held Remote Cantml

USING THE "LEARN" BUTTON
^ Ail
1. Press and release the "learn"
button on the motor unit. The
learn indicator light will glow
: steadily for 30 seconds. '
2. Within 30 seconds, press and
hold the button on the hand-held
remote* that you wish to operate
your garage door......................
3. Release the button when the
motor unit lights blink. It has
learned the code. If light bulbs are
not installed, two clicks will be
heard.
To Erase All Codes From Motor
To deactivate any unwanted remote,
first erase all codes: : T : : :
Press and hold the "learn" button on
motor unit until the learn indicator
light goes out (approximately 6 seconds). All previous
codes are now erased. Reprogram each remote or::::
keyless entry you wish to use.
USING THE PREMIUM CONTROL CONSOLE
1, Press and hold the button on the
hand-held remote* that you wish
to operate your garage door.
2. While holding the ENTER button,
press and hold the LIGHT button
on the Premium Control Console.
3. Continue holding the ENTER and
LIGHT buttons while you press :
the push bar on the Premium
Control Console (all three buttons
are held).
4. Release buttons when the motor
unit lights blink, it has learned the
code. If light bulbs are not. ....
installed, two clicks will be heard.
If provided with your garage door opener, the large
button is factory programmed to operate it. Additional
buttons on any
:
Security#-* 3-Function
remote or compact
remote can be ..........
programmed to operate
other Security#*
^
door openers.
35
*3-fiuarictioii ^
> :
garage