Programming - Craftsman SMART CONTROL Manual Del Propietário

Programming

Your garage door opener has been programmed at the factory to operate with your remote control. Older Craftsman
are not compatible, see page 46 for compatible accessories. Programming can be done through the door control or the learn button on
the garage door opener. To program additional remote controls refer to the instructions provided with the additional remote controls.
IMPORTANT NOTE: If your vehicle is equipped with a Homelink
and year of your vehicle. Visit www.homelink.com for additional information.
PROGRAM A REMOTE USING THE LEARN BUTTON
1. Press and release the Learn button on
the garage door opener. The Learn
indicator light will glow steadily for 30
seconds.
2. Within 30 seconds, press and hold the
button on the remote control.
3. Release the button when the garage door
opener light blinks. It has learned the
code. If light bulbs are not installed, two
clicks will be heard.
When replacing the light lens cover, ensure the antenna wires are
hanging straight down.
®
, you may require an external adapter depending on the make, model
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL OR
KEYLESS ENTRY PIN USING THE MOTION-DETECTING CONTROL
PANEL
1. Press the LEARN button on the door
control to enter Programming Mode.
2. Press the LEARN button again, the
LED will flash once.
3. Press the button on the remote
control that you wish to operate your
garage door.
OR
Enter a 4-digit personal identification
number (PIN) of your choice on the
keyless entry keypad. Then press the
ENTER button.
The garage door opener lights will flash
(or two clicks will be heard) when the
code has been programmed.
Repeat the steps above for programming
additional remote controls or keyless
entry devices.
39
®
accessories
The command LED
will flash once.
The command LED
will flash once again.
OR
? ? ? ?
PIN