Programming; To Erase The Memory - Craftsman 139.55918 Manual Del Propietário

Programming

Your garage door opener has been programmed at the factory to operate with your remote control. Older Craftsman
are not compatible, see page 40 for compatible accessories. Programming can be done through the door control or the learn button on
the garage door opener. To program additional remote controls refer to the instructions provided with the additional remote controls.
IMPORTANT NOTE: If your vehicle is equipped with a Homelink
and year of your vehicle. Visit www.homelink.com for additional information.
PROGRAM A REMOTE USING THE LEARN BUTTON
1. Press and release the Learn button on
the garage door opener. The Learn
indicator light will glow steadily for 30
seconds.
2. Within 30 seconds, press and hold the
button on the remote control.
3. Release the button when the garage door
opener light blinks. It has learned the
code. If light bulbs are not installed, two
clicks will be heard.
When replacing the light lens cover, ensure the antenna wires are
hanging straight down.

To Erase the Memory

ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES
1. Press and hold the learn button on garage door opener until
the learn LED goes out (approximately 6 seconds). All remote
control and keyless entry codes are now erased. Reprogram
any accessory you wish to use.
®
, you may require an external adapter depending on the make, model
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/
KEYLESS ENTRY PIN USING THE MULTI-FUNCTION CONTROL
PANEL
1. Press the LEARN button on the door
control to enter Programming Mode.
2. Press the LEARN button again, the
LED will flash once.
3. Press the button on the remote
control that you wish to operate your
garage door.
OR
Enter a 4-digit personal
identification number (PIN) of your
choice on the keyless entry keypad.
Then press the ENTER button.
The garage door opener lights will flash
(or two clicks will be heard) when the
code has been programmed.
Repeat the steps above for programming
additional remote controls or keyless
entry devices.
ERASE ALL DEVICES (INCLUDING ASSURELINK™ ACCESSORIES)
1. Press and hold the learn button on garage door opener until
the learn LED goes out (approximately 6 seconds).
2. Immediately press and hold the learn button again until the
learn LED goes out. All codes are now erased.
Reprogram any accessory you wish to use.
34
®
accessories
The command LED
will flash once.
The command LED
will flash once again.
OR
? ? ? ?
PIN