Programming; To Add Or Reprograma Hand-Heldremote Control; To Erase All Codes From Motor Unit Memory; 3-Function Remote Controls - Craftsman 139.53902D Manual Del Propietário

PROGRAMMING
NOTICE:If this Security,!,_garage door opener is operated with a non-rolling code transmitter, the technical measure in the receiver of
the garage door opener, which provides security against code-theft devices, will be circumvented. Theowner of the copyright in the
garage door opener does not authorize the purchaser or supplier of the non-rolling code transmitter to circumvent that technical
measure.
Your garage door opener has already been programmed at the factory to operatewith your hand-held remote control. The door will
open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security÷ ° 315 MHz remote controls.
To Add or Reprograma Hand-heldRemote Control
USINGTHE "LEARN" BUTTON
1. Press and releasethe "learn" button on
the motor unit. The learn indicator light
will glow steadily for 30 seconds.
2. Within 30 seconds, press and hold the
button on the hand-held remote control*
that you wish to operateyour garage door.
*3-Function Remote Controls (315 MHz)
If provided with your garage door opener, the large button is
factory programmed to operate
it. Additional buttons on any
Security÷ _ 3-Function remote
control or compact remote
control can be programmed to
operate other Security÷ _ garage
door openers.
To Erase All Codes From Motor Unit Memory
To deactivate any unwanted remote control, first erase all
Press and hold the "learn" button on motor
unit until the learn indicator light goes out
(approximately 6 seconds). All previous
codes are now erased. Reprogram each
remote control or keyless entry you wish to use.
3. Releasethe button when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks will
be heard.
\1/
35