Setting The Temperature; Lcd Display - BEAUTURAL 724UK-0001 Manual De Instrucciones

Setting the Temperature

EN
1. Plug in the iron. The power indicator light will turn red and beep. The iron will be in
DE
Standby mode and "OFF" will appear on the LCD display.
FR
ES
IT
Standby Mode
2. To select a temperature setting, press the Temperature Setting
you reach your desired setting from 1 to 9.
Note: See the fabric guide on the LCD display and read the garment's label to help
you determine which temperature setting to use.
Tip: If unsure of a garment's fiber, test a small area (on an inside seam or hem)
before ironing.
3. The digital display will show the setting number and fabric type. The fabric type will
flash on the display when heating.
4. When your set temperature is reached, the iron will beep once and the fabric type
will stop flashing.
5. To change temperature settings while ironing, just press the Temperature Setting
button. When a lower setting is selected, fabric type will flash until the iron
temperature has lowered to the correct level for that setting.
/ button until
Temperature
mark
Fabric type
4

LCD Display

Normal Status
Standby Mode Level 1 - Acrylic
Level 4 - Polyester Level 5 - Blended
Level 8 - Jeans Level 9 - Linen
Error Status
NTC short-circuit NTC lower than 50°C
• Unplug the iron from the power when the LCD panel shows an error status. Plug
the iron in again once the soleplate has cooled.
• If the LCD panel still shows an error status, contact qualified technicians to check
and repair the iron or contact our customer service.
Note: NTC stands for Negative Temperature Coefficient.
Level 2 - Nylon Level 3 - Silk
Level 6 - Wool Level 7 - Cotton
Auto Shutoff
Soleplate over 270°C±15°C
5
EN
DE
FR
ES
IT