Hex Wrench Storage - Makita M4302 Manual De Instrucciones

Installing or removing saw blade
CAUTION:
• Always clean out all chips or foreign matter
adhering to the blade and/or blade holder.
Failure to do so may cause insufficient tighten-
ing of the blade, resulting in serious personal
injury.
• Do not touch the blade or the workpiece imme-
diately after operation as they may be extremely
hot and could cause burn injury.
• Always secure the blade firmly. Insufficient tight-
ening of the blade may cause blade breakage or
serious personal injury.
1
► 1 . Hex socket head bolt 2. Hex wrench
To install the blade, loosen the bolt counterclockwise on
the blade holder with the hex wrench.
With the blade teeth facing forward, insert the blade into
the blade holder as far as it will go. Make sure that the
back edge of the blade fits into the roller. Then tighten
the bolt clockwise to secure the blade.
To remove the blade, follow the installation procedure
in reverse.
Adjusting roller
► 1 . Hex wrench 2. Hex bolt
► 1 . Roller 2. Saw blade
Loosen the hex bolt on the back of the base with
the hex wrench. Move the retainer so that the roller
contacts the blade lightly. Then tighten the hex bolt to
secure the base and the retainer.
However, when using the blade that does not have a
straight back, slide the retainer back so that the roller
will not contact the blade.
NOTE:
•

Hex wrench storage

2
► 1 . Hex wrench
1
When not in use, the hex wrench can be conveniently
stored.
OPERATION
•
2
•
•
5 ENGLISH
Occasionally lubricate the roller.
CAUTION:
Hold the tool firmly with one hand on the main
handle when using the tool. If necessary, the
front part of the tool may be supported by the
other hand.
Always hold the base flush with the workpiece.
Failure to do so may cause blade breakage,
resulting in serious injury.
Advance the tool very slowly when cutting
curves or scrolling. Forcing the tool may cause a
slanted cutting surface and blade breakage.
1
2
1