Measuring Area - DeWalt DW099E Manual Del Usuario

Operation
Measuring Distance to a Wall or Object
1.
Click (Figure
2. The tool will measure the distance from the bottom
of the tool to the wall or object (Figure
To measure from the top of the tool instead of the
bottom (Figure #2), hold
F
On the display window, the tool icon will change
from to
3.
Point the laser at the top of the tool (Figure
toward the wall or object whose distance you need
to measure (Figure
F
4. Click to measure the distance from the tool
to the wall or object.
5.
At the bottom of the display window (Figure
view the current measurement (Figure
To take a new measurement, click
current measurement up to the previous line on the
display window (Figure
E
Measuring Distances Continuously
To take a series of measurements as you move
around, change to Continuous Measure mode.
1. Click (Figure
2.
Point the laser at the top of the tool (Figure
toward the wall or object whose distance you need
to measure (Figure
F
3.
Click and hold
Continuous Measure mode.
4.
At the bottom of the display window
(Figure #2), view the current measurement
A
(Figure #3), which will keep changing as you
E
move the tool.
5.
To take the current measurement (from the tool to
the wall or object) and exit Continuous Measure
mode, click .
To take a new measurement, click
current measurement up to the previous line on the
display window. Then repeat steps 2-5.
#5) to turn on the tool.
A
#1).
F
for 2 seconds.
(Figure #5).
E
A
).
A
#3).
E
to move the
#2). Then repeat steps 2-5.
#5) to turn on the tool.
A
A
).
for 2 seconds to turn on the
to move the

Measuring Area

You can measure the area of a wall, floor, or object.
1. Click
2.
The tool will measure the distance from the bottom
of the tool to the wall or object (Figure
To measure from the top of the tool instead of the
bottom (Figure
On the display window, the tool icon will change
from
3.
Click to show
(Figure #4).
#1)
E
4. Measure the width.
• Point the top of the tool at one side of the target
(wall, floor, or object).
• Position the tool at one end of the target and
#2),
point the laser dot across the width. (Figure
#1 shows where to position the tool if you are
measuring from the bottom of the tool.)
• Click
the top of the display window.
5. Measure the length.
• Position the tool at one end of the target and
point the laser dot across the length. (Figure
#2 shows where to position the tool if you are
measuring from the bottom of the tool.)
• Click
#1)
on the second line of the display window.
6. View the Area measurement at the bottom of the
display window (Figure
(Figure #5) to turn on the tool.
A
#2), hold for 2 seconds.
F
to (Figure #5).
E
on the display window
to display the width measurement at
to display the length measurement
#3).
E
GB
#1).
F
G
G
5