Measuring Continuously
E
To take a series of measurements as you move
around, change to Continuous Measure mode
(Figure
).
K
1.
Point the tool's laser (Figure
or object, and not toward anyone's eyes.
2.
Press
Figure
and display the red laser dot.
3.
Make sure the tool position setting (Figure
is correct for taking the measurement.
4.
Select
as the measurement type.
• Press
to display the Main Menu
(Figure
E 2
• Press
to select
• Press
Menu (Figure
• Press the arrow buttons to select
• Press
5.
Point the tool's laser (Figure
the wall or object whose distance you need to
measure (Figure
6.
At the bottom of the screen, view the current
measurement (Figure
changing as you move the tool.
7.
To take the current measurement (from the tool to
the wall or object) and exit Continuous Measure
mode, press
To take a new measurement, press
the current measurement up to the previous line on
the screen. Then repeat steps 4-7.
Measuring Area
You can measure the area of a wall, floor, or object
(Figure
).
L
1.
Point the tool's laser (Figure
or object, and not toward anyone's eyes.
2.
Press
(Figure
and display the red laser dot.
3.
Make sure the tool position setting (Figure
is correct for taking the measurement.
14
) toward a wall
A 1
) to turn the tool on
A 3
).
.
to display the Measurement Type
).
E 3
.
.
) toward
A 1
).
K 1
), which will keep
K 2
.
to move
) toward a wall
A 1
) to turn the tool on
A 3
4.
Select
• Press
(Figure
• Press
• Press
Menu (Figure
• Press the arrow buttons to select
• Press
5.
Measure the width (Figure
)
C 4
• Point the top of the tool at one side of the wall,
floor, or object.
• Position the tool at one end of the wall, floor,
or object and point the laser dot across the
width. (Figure
the tool if you are measuring from the bottom
of the tool.)
• Press
at the top of the screen.
6.
Measure the length (Figure
• Position the tool at one end of the wall, floor,
or object and point the laser dot across the
length. (Figure
the tool if you are measuring from the bottom
of the tool.)
• Press
on the second line of the screen.
7.
View the Area measurement at the bottom of the
screen (Figure
Adding/Subtracting 2 Areas
You can measure the area of a wall, floor, or object
and then add it to, or subtract it from, the area of
another wall, floor, or object (Figure
1.
Point the tool's laser (Figure
or object, and not toward anyone's eyes.
2.
Press
and display the red laser dot.
3.
Make sure the tool position setting (Figure
is correct for taking the measurement.
)
C 4
as the measurement type.
to display the Main Menu
).
E 2
to select
.
to display the Measurement Type
).
E 3
.
).
L 1
shows where to position
L 1
to display the width measurement
L 2
shows where to position
L 2
to display the length measurement
).
L 3
M
A 1
(Figure
) to turn the tool on
A 3
.
).
).
) toward a wall
)
C 4