Replacing The Brush - Tennant CS5 1251584 Manual De Instrucciones

• Pull the handle up perpendicular to the machine.
•
Front squeegee:
•
•
•
•
• Remove the blade.
•
it can be used until both edges are worn out, or replace with a new
blade, clipping it to the slots in the body of the squeegee;
•
described previously.
Rear squeegee:
• Lower the squeegee control lever.
•
•
•
•
•
it can be used until both edges are worn out, or replace with a new
blade, clipping it to the slots in the body of the squeegee;
•
described previously.

Replacing the brush

The brush presents a number of tufts, coloured red, with bristles shorter
to the same length as the red bristles, the brush must be replaced. For
directions on replacement of the brush, refer to the sections "Releasing
the brush/pad drive board" and "Fitting the brush/pad drive board".
Fig.45
Fig.44
EN
1
2
Fig.39
1
Fig.40
Fig.41
1
Fig.42
1
Fig.43
23
2