OPERATION
3. Connect the chain to the solution control lever.
Connect the solution feed tube to the solution
supply connector on the machine base (Figure 4).
WARNING: To reduce the risk of fire, use only
commercially available floor cleaners and waxes
intended for machine operation.
WARNING: Do Not Use Flammable Liquids Or
Operate Machine In Or Near Flammable Liquids,
Vapors Or Combustible Dusts.
This machine is not equipped with an explosion
proof motor. The electric motor will spark upon
start up and during operation which could cause a
flash fire or explosion if machine is used in an
area where flammable vapors/liquids or
combustible dusts are present.
FOR SAFETY: When using machine, follow mixing
and handling instructions on chemical containers.
MACHINE SETUP
INSTALLING PAD DRIVER / PAD / BRUSH
FOR SAFETY: Before leaving or servicing
machine, unplug cord from wall outlet.
12
FIG. 3
FIG. 4
1. Pull the handle height adjustment lever and raise
the handle to the upright position. Carefully tilt the
machine backwards and rest the handle on the
floor (Figure 5).
2. Position pad on pad driver. If machine is equipped
with plastic centerlock, secure pad with lock
(Figure 6).
NOTE: Consult your authorized distributor for pad and
brush recommendations. Use only manufacturer
supplied or approved pad drivers and brushes.
3. Position the pad driver/brush on the drive motor
hub and turn it counter-clockwise to engage
(Figure 7).
4. Return machine to the upright position.
Tennant 2100/2120/2130/2140/2150 (10–02)
FIG. 5
FIG. 6
FIG. 7