Makita 3901 Manual De Instrucciones página 8

1
004598
10. For Corner Joint only
Place the tool on the workpiece so that the blade is
facing down.
004599
For T-Butt Joint only
Remove the angle guide from the tool. Place the tool on
the workpiece so that the blade is facing down.
004600
11. Repeat the steps 6 - 8 to cut the slots in the
horizontal or the other workpiece.
If you do not need to center the blade in the board
thickness, proceed as follows:
For Corner Joint, Miter Joint, Frame Joint and
Edge-To-Edge Joint only
004601
1. For
Edge-To-Edge
Joint
8
Remove the angle guide from the tool. Set the
•
fence at 90° for Corner Joint, Frame Joint and
Edge-To-Edge Joint or at 45° for Miter Joint.
Follow steps 1 - 11 excluding steps 5 and 10
•
described above.
For T-Butt Joint only
004602
004603
Fit the two workpieces together as they will appear
•
in the finished joint position.
Lay the vertical workpiece on the horizontal one.
•
Clamp both workpieces to the workbench.
Remove the angle guide from the tool.
•
Follow the steps 2, 4, 6, 7, 8 and 11 described
•
above.
How to trim wall or ceiling panels
First unplug the tool. Open the blade cover and replace
the existing cutter blade with an optional circular saw
blade 110 mm (4-3/8") in diameter.
1
2
3
004604
Refer to the "Removing or installing the blade" section
which was described previously. Remove the rubber
facing from the base. Then close and secure the blade
cover. Now the max. depth of cut is 25 mm (1").
1. Lock nut
4 2. Circular saw
blade
3. Inner flange
4. Blade cover