Pairing A Bluetooth Device - Alto Professional ACTIVE-8 WIRELESS Guia Del Usuario

Pairing a Bluetooth Device

1. Turn on your Bluetooth device.
2. Power on ACTIVE-8
automatically go into pairing mode to search for
Bluetooth devices. You will know you are in
pairing mode when the LED is blank.
3. If your Bluetooth device is not able to pair to ACTIVE-8 Wireless, press the Disconnect
button on ACTIVE-8 Wireless to break previous Bluetooth connections and reset the
Bluetooth module.
4. Navigate to your Bluetooth device's setup screen, find "ALTO ACTIVE-8" and connect.
Note: If your Bluetooth device prompts for a pairing code, enter "0000".
5. ACTIVE-8 Wireless Paired LED will light up solid when it is paired.
Note: Users should consider updating their OS if experiencing trouble with pairing or
playing music.
6. To disconnect pairing, press the Disconnect button on ACTIVE-8 Wireless.
7. To connect to another Bluetooth device, repeat steps 3-4.
Note: Maximum range will be achieved when using devices with Bluetooth 4.0.
Troubleshooting
If the sound is distorted: Try lowering the volume control of your sound source or musical
instrument. Also, try to reduce the overall volume of ACTIVE-8 Wireless.
If there is too much bass: Try adjusting the tone or EQ control on your sound source to
lower the bass level. This will allow you to play the music louder before clipping (distortion)
occurs.
If there is a high-pitched whistling noise when using microphones: This is probably
feedback. Point the microphones away from the speaker.
If you can't hear the microphone over the music volume: Turn down the music volume
from your source.
6
Wireless and it
Note: To avoid interruptions during
playback, we recommend putting
will
your Bluetooth device in Airplane
Mode and deactivating any alarms
or alerts before activating Bluetooth.