Troubleshooting - Dometic PREMIUM Instrucciones De Montaje Y De Uso

Troubleshooting

End of SD card transfer
Wait when opening with R.E.O.S.
code
Repeat R.E.O.S. code
Safe blocked due to back cover
secured with anti-tamper code
Safe blocked due to use of
mechanical key with anti-tamper
code
Safe blocked
Wait when opening with anti-
tamper code
Repeat anti-tamper code
Code requested
11 Troubleshooting
If you are unable to rectify the fault, get in touch with a specialist workshop.
Display Fault
BAT-LO The safe does not
close.
ERROR A continuous audible
signal sounds.
The safe will not accept
the master code.
ERROR 2 The bolts do not
extend completely.
26
Display
DSDXX
DELAY
REPEAT
A-001
A-002
DELAY
DELAY
CODE
Possible cause
The battery is low.
False code
Time for entering code
has elapsed.
Wrong master code
The locking
mechanism is not
functioning correctly.
MDD403
Sound
3 short beeps
3 short beeps
3 short beeps
3 short beeps
1 short beep
Suggested remedy
➤ Replace the batteries.
➤ Enter the correct code.
➤ Enter the code within
8 seconds.
➤ Enter the correct master
code.
➤ Make sure the bolts are
not jammed in the
cupboard.
➤ Check the connections
on the circuit board.
➤ Replace the motor.
EN