MDD403
7
Installing safe
7.1
Notes on installation
A
NOTICE!
The safe must only be installed by qualified specialists.
Follow the instructions when installing.
Carefully check the safe for damage once you have removed it from the
packaging. If there is visible damage, contact the manufacturer (see rear for
addresses).
Install the safe on a flat and even surface.
Select a location for installation which is a sufficient distance from heat sources
(e.g. radiators). Avoid installing in locations with temperatures of under 0 °C and
over 45 °C.
Avoid damp ambient conditions (e.g. in the bathroom and swimming pool) in
order to avoid condensation forming in the device.
Select a fastening material (screws with plugs, if necessary) which is appropriate
for the base.
7.2
Attaching the safe
➤ Select a suitable installation location.
➤ Select an appropriate method for installation (attachment on the rear or on the
underside).
➤ Mark the drill holes (fig. 2, page 3 and fig. 3, page 3).
➤ Pre-drill the hole in the mounting location (e.g. in the wall or cupboard).
➤ Pull out the drawer, remove the four screws of the guide rail and take the drawer
out off the case (fig. 4, page 4).
➤ Attach the safe with suitable fastening material.
➤ Attach the drawer on the guide rails and push it into the case.
EN
Installing safe
9