Design Features - Rockford Fosgate Punch P300-8P Manual De Instrucciones

Design Features

Gain Control
The input gain control is preset to
match the output of most source
units.
Variable Crossover
Is a built-in 12dB/octave Butterworth
filter with a crossover point variable from
50Hz to 200Hz.
Power/Protect LED
Power LED illuminates
blue when the unit
is turned on. Protect
LED illuminates red
if a short circuit or to
low of an impedance
is detected at the
speaker connections.
The amplifier will
automatically shut
down if this occurs.
Punch Bass
This is an adjustable Bass control
adjustment variable from 0dB to +12dB
@ 45Hz.
6
Phase Switch
Allows you to select the output
phase of the amplifier between 0°
and 180°.
Power Connector
The power connector allows for quick
connection and disconnection of the
amplifier's Remote, power and ground
source. The power and ground are
set-screw wire connectors and will
accommodate 4 AWG. The remote is
a set-screw wire connector and will
accommodate 8 AWG.
Input Level
Set the Input Level switch to match the outputs of your
source unit.(LO - RCA or HI - Speaker Level)
Auto Turn On
Three different automatic turn-on modes can be
selected; REM(+12V), DC Offset, and Audio.
Audio Input
The RCA/Speaker Harness utilizes either
speaker level (high-level) or RCA (low-
level) inputs.
Remote Punch Level
When connected, the "Gain Control"
is linked and allows you to remotely
control the output level of the amplifier
from the dash or center console.
illus.-2.1