Descargar Imprimir esta página

Helvex Classica M-1005 Guia De Instalacion página 2

Mezcladora con desagüe de push

Publicidad

Retire el separador, rondana, empaque
2
y tuerca.
/
Remove the spacer, washer.
gasket and nut.
empaque
antiderrapante
gasket skid
rondana
washer
tuerca
nut
Retire el separador e
5
inserte la rondana de fibra
al cuerpo lateral.
Remove
the escutcheon spacer
and insert the fiber side
body.
separador
separator
rondana
de fibra
rubber
washer
tuerca
nut
Enrosque el cuerpo central,al espárrago
8
de la salida, posteriormente enrosque
las mangueras (incluidas) al cuerpo
central y a los cuerpos laterales.
the central body, the output stud, then screw
the hose (included) to the central body and
lateral bodies.
espárrago
output stud
cuerpo central
central body
Inserte la salida en el lavabo y
3
verifique que se coloque el
empaque
the output in the sink and check
that the gasket slip is placed.
separador
separator
Limpie la superficie.
Clean the surface.
empaque
gasket
Coloque el cuerpo lateral con tuerca, rondana y el
6
separador, considerando la altura necesaria para el
correcto funcionamiento de sus manerales, inserte el
empaque y enrosque el chapetón, posteriormente
apriete la tuerca.
washer and escutcheon considering the height
needed for the proper functioning of their-handle,
insert the washer and screw the escutcheon, then
tighten the nut.
caliente
hot
Abra el suministro de agua y purgue
9
la línea de alimentación.
water supply and purgue the lines
/
Screw
fedding.
líneas de
alimentación
lines fedding
mangueras
hoses
antiderrapante./ Insert
empaque
antiderrapante
gasket skid
/ Place the side body with nut,
chapetón
empaque
escutcheon
gasket
1,5 cm
chapetón
rondana
separador
rubber
tuerca
escutcheon
nut
fría
spacer
cold
/ Open the
fría
cold
caliente
hot
Coloque el separador, rondana,
4
empaque y enrosque la tuerca para
sujetar la
salida./ Place the spacer,
washer, gasket and tighten the nut to
hold the output.
separador
rondana
separator
washer
empaque
gasket
tuerca espárrago
nut asparagus
Coloque el separador, inserte los
7
manerales y enrosque el opresor.
Place the separator, insert the
manerals and tighten the screw.
maneral
maneral
separador
separator
opresor
set screw
Conecte las mangueras (no incluidas) a
10
los cuerpos laterales y posteriormente a
la línea de alimentación.
/ Connecting
hoses (not included) to the lateral bodies
and subsequently the supply line.
1/2-14 NPSM
mangueras
(no incluidas)
hoses
(not included)
válvula angular
( no incluida)
angle valve
(not included)
/
2

Publicidad

loading