Optional Components - baltur LCM 100 Guida Rapida

OPTIONAL COMPONENTS

9.1.1 RANGE LIMITS
You must set limit values in the parameters, which switch the burner on
and off. If the burner shuts down and the actual temperature has not yet
reached the switch-on threshold again, a display informs the operator that
the power control unit refuses a start-up.
!
1
0
Check that the DIP1 is on "1" in
order to communicate with the
control unit
0006081547_201210
9.1.2 ENTER SET POINT OF POWER CONTROL
If you confirm the settings with ENTER in a preset time slot, the
value is stored in the parameter. Otherwise the changes value
is rejected.
2 / 18
Use the arrowkeys to select the
switching point (ON or OFF)
and to adjust the switching
point after-wards.