Avoiding Flare-Ups; Cleaning The Grill; Storing The Appliance; Cleaning The Bowl - Barbecook BASIC BLACK Manual De Instrucciones

MAN_CHARCOAL_BLACK_BBC_151005_B.book Page 7 Monday, October 5, 2015 4:19 PM

7.4 Avoiding flare-ups

Flare-ups are sudden flames that spark from the bowl when you
are grilling. They are usually caused by dripping fat or marinade.
During grilling, some flare-ups are normal. Too many flare-ups,
however, increase the temperature in the bowl and can ignite
accumulated fat. To avoid flare-ups:
Make sure the bowl is clean before you start grilling. We
•
recommend cleaning the bowl after each use.
Remove excess fat and marinade from the meat. You can
•
also use a grill pan for fatty and/or marinated meat.
7.5 Grilling under the Dome
This information only applies to models Optima and Major.
Models Basic and Arena cannot be equipped with a Dome.
To use your appliance to its full potential, you can equip it with a
Dome. The Dome is a half-open, shell-shaped lid that reflects the
heat of the charcoal back onto the food. As a result, your food is
heated from the bottom and from the top. This allows you,
amongst others, to evenly cook large pieces of meat, to prepare
beer canned chickens and even to grill pizzas.
Use Dome 223.0043.000 for model Optima and Dome
0
223.0050.000 for model Major. For more information on
the Dome, refer to www.barbecook.com.
8 MOVING THE APPLIANCE
This information only applies to models Optima, Major and Arena.
Model Basic is not equipped with an accessory bracket.
The main steps of this task are illustrated in Figure 5, on
3
page 115.
Let the appliance cool down completely. Never move the
1
appliance when in use or when still hot.
Remove the grill from the appliance and put the accessory
2
bracket in upright position (Fig. 5a).
Lift the appliance at the accessory bracket (Fig. 5b) and
3
move it to the desired location.
9 MAINTAINING THE APPLIANCE

9.1 Cleaning the bowl

This information only applies to models Optima, Major and Arena.
Model Basic is not equipped with a QuickStop
the bowl of the Basic, just brush the ashes into a bucket.
The main steps of this task are illustrated in Figure 6, on
3
page 115.
We recommend cleaning the bowl after each use. With the
QuickStop ® system, this is done in no time. Proceed as follows:
Let the appliance cool down completely and remove the grill.
1
Close the air supply holes at the bottom of the central pipe
2
(Fig. 6a).
Remove the bottom grid from the bowl and brush the ashes
3
into the pipe (Fig. 6b).
Release the clips at the bottom of the central pipe (Fig. 6c).
4
Lift the upper section of the appliance from the water
5
container and put it aside (Fig. 6c).
Pour the water with the ashes into a bucket (Fig. 6d).
6
Put the upper section of the appliance back on the water
7
container and close the clips.
Put the bottom grid back in the bowl.
8

9.2 Cleaning the grill

We recommend cleaning the grill after each use, with the
Barbecook cleaner. Proceed as follows:
Spray the foam on the grill and let it act for a while.
1
The foam discolours, as it soaks off the dirt and greases.
Remove the foam with a soft sponge and water and rinse the
2
grill thoroughly.
Dry the grill well and store it in a dry place. This prevents
3
formation of rust.
You can also clean the grill with a soft detergent or with
2
sodium bicarbonate. Never use oven cleaners on the grill.

9.3 Storing the appliance

Store the appliance in a dry place (indoors, under a shelter...)
after each use. To extend the lifespan of your appliance, we
recommend covering it with a Barbecook cover (223.8600.100).
Register your appliance at
which cover you need.
Make sure the appliance is completely dry before you
2
store it. This prevents formation of rust.
9.4 Maintaining enamel, stainless steel
and chrome
The appliance is composed of enamelled, stainless steel and
chromed parts. Each material has to be maintained differently:
Material
Enamel
Stainless steel
and chrome
To prevent formation of rust on stainless steel, avoid
1
contact with chlorine, salt and iron. We recommend not
®
system. To clean
using the appliance near the coast, near railways or near
swimming pools.
Damages caused by not following these instructions are
1
regarded as inadequate maintenance and are not
covered by the warranty.
Below the exploded view of your appliance (second part of the
manual), you find a list with all parts of which the appliance is
composed. This list includes a symbol that specifies the material
of each part, so you can use it to check how you have to maintain
a particular part. The parts list uses the following symbols:
Symbol
www.barbecook.com
www.barbecook.com to find out
How to maintain this material
Do not use sharp objects and do not knock
•
against a hard surface.
Avoid contact with cold liquids while still hot.
•
You can use metal sponges and abrasive
•
detergents.
Do not use aggressive, abrasive or metal
•
detergents.
Use soft detergents and let them act on the
•
steel.
Use a soft sponge or cloth.
•
Rinse thoroughly after cleaning and dry well
•
before storing.
Material
Enamel
Chrome
Stainless steel
7