Installation And Connection - Panasonic NN-CD757 Instrucciones De Funcionamiento

Examine your microwave oven
Unpack the oven, remove all packing material, and examine the
oven for any damage such as dents, broken door latches or
cracks in the door. If you find any damage, notify your dealer
immediately. Do not install a damaged microwave oven.
Earthing instructions
IMPORTANT: THIS UNIT HAS TO BE PROPERLY EARTHED
FOR PERSONAL SAFETY.
If your AC outlet is not grounded, it is the personal responsibility
of the customer to have it replaced with a properly grounded wall
socket.
Operation voltage
The voltage has to be the same as specified on the label on the
oven. If a higher voltage than specified is used, it may cause a fire
or other damages.
Placement of the Oven
1. Place the oven on a flat and stable surface, more than 85 cm
above the floor.
2. When this oven is installed, it should be easy to isolate the
appliance from the electricity supply by pulling out the plug or
operating a circuit breaker.
3. For proper operation, ensure a sufficient air circulation for the
oven. This oven is intended for counter-top and built-in use
only. It is not intended for use inside a cupboard.
Counter-top use:
a. Allow 15 cm of space on the top of the oven, 10 cm at the
back, 5 cm on one side, and the other side must be opened
more than 40 cm.
b. If one side of the oven is placed flush to a wall, the other
side or top must not be blocked.
5cm
Counter-top
Built-in
This oven may be built in by using the proper trim kit, white NN-
TKA70WBBP, silver NN-TKA70MBBP, which may be purchased
from a local Panasonic dealer.

Installation and Connection

15cm
10cm
Open
4. Do not place this oven near an electric or gas cooker range.
5. The feet should not be removed.
6. This oven is only for household usage. Do not use outdoors.
7. Avoid using the microwave oven in high humidity.
8. The power cord should not touch the outside of the oven.
Keep the cord away from hot surfaces. Do not let the cord
hang over the edge of a table or work top. Do not immerse
the cord, plug or oven in water.
9. Do not block the air vents on the top and back of the oven. If
these openings are blocked during operation the oven may
overheat. In this case the oven is protected by a thermal
safety device and resumes operation only after cooling
down.
WARNING
1. The door seals and door seal areas should be cleaned with a
damp cloth.
The appliance should be inspected for damage to the door
seals and door seal areas and if these areas are damaged
the appliance should not be operated until it has been
repaired by a service technician trained by the manufacturer.
2. Do not attempt to tamper with or make any adjustments or
repairs to the door, control panel housing, safety interlock
switches or any other part of the oven. Do not remove the
outer panel from the oven which gives protection against
exposure to microwave energy.
Repairs should only be done by a qualified service person.
3. Do not operate this appliance if it has a damaged CORD OR
PLUG, if it is not working properly, or if it has been damaged
or dropped. It is dangerous for anyone other than a service
technician trained by the manufacturer to perform repair
service.
4. If the supply cord of this appliance is damaged, it must be
replaced with the special cord available from the
manufacturer.
5. Only allow children to use the oven without supervision when
adequate instructions have been given so that the child is
able to use the oven in a safe way and understands the
hazards of improper use.
6. Liquids and foods must not be heated in sealed containers
since they are liable to explode.
7. This oven is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge unless they
have been given supervision or instruction concerning the
use of the oven by a person responsible for their safety.
Children should be supervised to ensure they do not play
with the oven.
En-1