Briteq BT-70LS Manual De Instrucciones página 10

ENGLISH
Starting from these defaults you can easily make your
additional settings. The other setup parameters remain
unchanged.
 Press the MENU button for about 2 seconds to store the setting
and to return to running mode.
Reset
Used to force a reset of the unit.
 Press the MENU button until the display shows "Reset".
 Press the ENTER button to reset the unit.
Please also check
configuration of the unit to find out how you can force a reset by
DMX.
Offset Adjust
Used to adjust the home position of several functions:
Make sure that the unit is connected to a DMX-controller and set to
14CH channel mode: set ch6 + ch7 to maximum.
If you're not already in the setup menu, just press the MENU button
shortly to enter the setup menu ("DMX Address" is shown on the
display)
 Now press the ENTER button for at least 5 seconds to go into
offset mode.
 Use DOWN and UP buttons to select the function that you want
to adjust
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP buttons to adjust the home position
 Press the ENTER button to select your setting.
 Press the MENU button for about 2 seconds to store the setting and to return to running mode.
ELECTRICAL INSTALLATION + ADDRESSING
Important: The electrical installation should be carried out by qualified personal only,
according to the regulations for electrical and mechanical safety in your country.
Electrical installation for 1 standalone unit:
 Just insert the mains cable. The unit starts working immediately in stand-alone mode.
Remark1: You can connect a CA-8 or RF-8 remote controller to the unit if you want to have more control.
Refer to "how to operate the unit" to learn how to do this.
Remark2: if there's no output, please make sure to set the unit in master mode and set the blackout mode
to "NO" and Sound State to "On" (see previous chapter)
Electrical installation for two or more units in master/slave:
In this mode the units will show a synchronized show, working to the rhythm of the beat.
 Connect 2 to maximum 16 units together using good quality balanced microphone cables. The first unit
in the chain will automatically act as the master, the other units will act automatically as slaves.
 Make sure that all units are connected to the mains.
 Done!
Remark: You can connect a CA-8 remote controller to the master unit if you want to have more control
over the master/slave operation
Remark2: if there's no output, please make sure to set the first unit in master mode and set the blackout
mode to "NO" and Sound State to "On" (see previous chapter)
BRITEQ
®
the chapter about the DMX-channel
8/79
OPERATION MANUAL
BT-70LS