Briteq BT-70LS Manual De Instrucciones página 12

ENGLISH
 To prevent strange behavior of the light effects, due to interferences, you must use a 90Ω to 120Ω
terminator at the end of the chain. Never use Y-splitter cables, this simply won't
work!
 Make sure that all units are connected to the mains.
 Each light effect in the chain needs to have its proper starting address so it knows
which commands from the controller it has to decode. In the next section you will
learn how to set the DMX addresses.
 HOW TO SET THE RIGHT STARTING ADDRESS:
Refer to the previous chapter (DMX-512 address setting) to learn how to set the starting address on this unit.
The starting address of each unit is very important. Unfortunately it is impossible to tell you in this user
manual which starting addresses you have to set because this completely depends on the controller you will
use... So please refer to the user manual of your DMX-controller to find out which starting addresses you
must set.
DMX-CONFIGURATION OF THE BT-70LS IN 1CH MODE:
1CH
1
DMX-CONFIGURATION OF THE BT-70LS IN 14CH MODE:
14CH
1
2
3
4
5
6
7
BRITEQ
®
VALUE
000 - 007 Standby
Show 1
008 - 067
Show 2
068 - 127
128 - 187 Show 3
Show 4
188 - 247
Random Show
248 - 255
VALUE
Pan
000 - 255
Pan Fine (Least significant bit)
000 - 255
Tilt
000 - 255
Tilt Fine (Least significant bit)
000 - 255
Pan / Tilt Speed (000 = fast ~ 255 = slow)
000 - 255
Dimmer (0 to 100%)
000 - 255
Strobe / Shutter effect
000 - 007 Shutter closed (no output)
008 - 015 Shutter open
016 - 131 Strobe 1 (slow → fast)
132 - 139 Shutter open
140 - 181 Strobe 2: slow open / instant close (slow → fast)
182 - 189 Shutter open
190 - 231 Strobe 3: instant open / slow close (slow → fast)
232 - 239 Shutter open
240 - 247 Strobe 4: random strobe
248 - 255 Shutter open
10/79
OPERATION MANUAL
SHOW
FUNCTION
BT-70LS