Briteq BT-70LS Manual De Instrucciones página 9

ENGLISH
 Once the right delay is shown on the display, press the ENTER button select it.
 Press the MENU button for about 2 seconds to store the setting and to return to running mode.
Dimmer Calibrate
Due to tolerances in the production process, not all LEDs have exactly the same brightness,
therefore you can use this option to match the Brightness of different machines.
 Press the MENU button until "Dimmer Calibrat" is shown on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP buttons to select a value between "50" (lowest brightness) and "100" (highest
brightness).
 Once the brightness is found, press the ENTER button select it.
 Press the MENU button for about 2 seconds to store the setting and to return to running mode.
Auto Test
Used to activate the internal "self-test" program which checks all possibilities of the unit.
 Press the MENU button until the display shows "Auto Test".
 Press the ENTER button to start the internal self-test program.
 To go back to the functions press the MENU button.
Temperature inside the unit
Used to show the temperature inside the unit
 Press the MENU button until the display shows "Temp.".
 Press the ENTER button to show the internal temperature of the unit on the display.
 To go back to the functions press the MENU button again.
If you want to go back to normal running mode: press the MENU button for about 2 seconds.
Fixture Time
Used to show the number of working hours of the unit.
 Press the MENU button until the display shows "Fixture Time".
 Press the ENTER button to show the number of working hours in the display.
 To go back to the functions press the MENU button.
Firmware version
Used to show the software version that is installed in the unit
 Press the MENU button until the display shows "Firmware Version".
 Press the ENTER button to show the software version on the display.
 To go back to the functions press the MENU button.
Defaults
Used to choose between 2 sets of default settings, often used by rental companies:
PRO-defaults: basic settings for use on professional DMX-controllers.
AUTO-defaults: basic settings for easy master/slave use.
 Press the MENU button until the display shows "Defaults".
 Press the ENTER: to avoid accidental loss of your settings, the display shows "Confirm?":
 Use DOWN and UP buttons to select "Yes" or "No" and confirm by pressing the ENTER button.
 When you select "Yes", you have the choice between 2 options, each with their own settings:
Settings
Channel mode
Split Colors
Slave Mode
Blackout Mode
Sound State
Sound Sense
Pan Inverse
Tilt Inverse
Backlight
Function Delay
BRITEQ
®
PRO def AUTO def
14ch 5MSL
Yes No
Slave 1 Slave 1
Yes No
Off On
90 90
No No
No No
No Yes
3s 3s
7/79
OPERATION MANUAL
BT-70LS