How To Use The Appliance - Fagor DH-315 D Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

interior
26/10/04
At high speed, the dehumidifying effect is
better.
At low speed, the dehumidifying effect is
not as good, but it is quieter.
8. Multidirectional air flow
The air outlet can be directed upwards or
backwards.
6. OPERATING INSTRUCTIONS
OPERATING PANEL (Fig. 2)
Buttons
"STOP/START" button. Press it to
switch the appliance on or off.
"MODE" button. Press it to select
"VENTILATION" or
"DEHUMIDIFIER" mode.
"FAN" button. Press it to select
"HIGH VENTILATION SPEED" or
"LOW VENTILATION SPEED".
"DISPLAY" button. Press it to
display the "TEMPERATURE or
HUMIDITY" on the liquid crystal
display.
Indicators
Green ON light
When you press
the appliance on, the green light
comes on. It will go off when you
switch the appliance off.
NOTE: The appliance will not
automatically switch back on, even
when the power is restored, after a
power cut. Press the
button again to switch it back on.
RED water-tank-full light
If the water tank is full or not
properly in place, the red light will
flash and the alarm will sound, until
the tank has been emptied or has
been put properly back into place.
Note: In VENTILATION mode, the
red light will flash, if the water tank is
full or is not properly in place.
10:03
Página 16
%RH Selected
to switch
17
However, this will not affect the
VENTILATION functions.
Display screen
High speed
DEHUMIDIFIER
VENTILATION
Instructions:
1. When you press the
symbols
and
alternately on the liquid crystal display;
2. When you press the VENTILATION
button, the symbols
appear alternately on the liquid crystal
display;
3. When you press the display button
the humidity and temperature will appear
alternately on the liquid crystal display.

7. HOW TO USE THE APPLIANCE

A. Basic requirements:
Normal temperature range: the ambient
temperature range is: 5ºC – 32ºC
Input voltage: 220V~ - 240V~ 50 Hz
Position: place it on a horizontal surface
(slope of less than 5º)
B. How it operates
1. How the DEHUMIDIFIER operates
Press the
button. The unit will
start to operate in the mode pre-
established by the manufacturer and the
symbol "
" will appear on the
liquid crystal display. In this case, the
humidity is 60%RH. If you want to
change this configuration, follow the
instructions given below:
Adjusting the humidity
The humidity can be adjusted in
DEHUMIDIFIER mode. Each time you
press the
, button you increase the
humidity value by 5% RH up to 80%RH.
Low speed
%RH in room/
ºC in room
, button, the
will appear
and
will

Publicidad

Tabla de contenido
loading

Tabla de contenido