Install The Camera On A Bracket Mount (Sold Separately); Install The Midspan - Axis P55-E Serie Guia De Instalacion

AXIS P55–E Series

Install the Camera on a Bracket Mount (sold separately)

NO TICE TICE
NO NO TICE
To comply with the IP66-rated design of the camera and maintain the IP66 protection,
the supplied RJ45 Push-pull Connector (IP66) shall be used. Alternatively, use the RJ45
IP66-rated cable with premounted connector which is available from your Axis reseller. Do
not remove the plastic network connector shield from the camera.
1. Install the selected bracket according to the instructions supplied with the bracket. If
drilling is required, make sure to use drill bits, screws and plugs that are appropriate for
the material.
2. Connect supplied RJ45 Push-pull Connector (IP66) to the network cable according to the
instructions supplied with the connector.
3. Secure the camera using the supplied safety wire.
1
Screw
2
Slots for unit holders
3
Safety wire
4. Connect the network cable to the camera.
5. Slide the unit holders on the network camera into the slots in the mounting bracket and
rotate the camera unit.
6. Secure the network camera to the mounting bracket by tightening the screws.

Install the Midspan

The supplied midspan enables Axis network video products with high power consumption to receive
data and power over the same network cable.
3
16
1
2