Intended Use - Worx Sonicrafter WX682 Manual Original

SYMBOLS
To reduce the risk of injury, user
must read instruction manual
Warning
Wear ear protection
Wear eye protection
Wear dust mask
Do not dispose of batteries.
Li-I on
Return exhausted batteries
to your local collection or
recycling point
Do not expose to rain or water
Do not burn
Avoid danger of injury from the
sharp edges of the accessories.
Accessories can become very
hot while working, presenting
danger of burns!
Make sure the battery is
removed prior to changing
accessories.
Wear protective gloves
Oscillating Tool
High oscillation frequency.
Low oscillation frequency.
LED light is a battery capacity
=
indicator and will flash when
- - -
- - -
power gets low .
Waste electrical products
should not be disposed of with
household waste. Please recycle
where facilities exist. Check with
your Local Authority or retailer
for recycling advice.
Cylindrical lithium Ion battery
cells with max diameter of
18mm and max height of
65mm; "x" represents a
xINR18/65-y
number cells serial connected,
blank if 1; "-y" represents a
number of cells paralleled
connected, blank if 1.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.

INTENDED USE

The power tool is intended for sawing and
remodeling wooden materials, plastic, plaster, non-
ferrous metals and fasteners (e.g. nails and clamps)
as well as for working on soft wall tiles and for dry
grinding of small surfaces. It is especially suitable for
working close to edges and for flush cutting.
9
EN