Moving The Wet/Dry Vac; Blowing Feature - Workshop WS0600SS0 El Manual Del Propietario

Moving the Wet/Dry Vac

Should it become necessary to pick the
Vac up to move it, DO NOT pick the Vac
up by the carry handle unless the dust
drum is empty. To avoid dropping the
Vac, due to latches releasing or possible
part breakage, pick the Vac up by the
dust drum.

Blowing Feature

Your Wet/Dry Vac features "Full Blowing".
It can blow sawdust and other debris.
Follow the steps below to use your Vac
as a blower.
1. Locate the blowing port of your
Wet/Dry Vac.
2. Insert the larger end of the hose into
the blowing port of the Vac.
3. (Optional) Attach the extension wand
to the swivel end of the hose.
4. Turn the Vac on and you are ready to
use your Vac as a blower.
OPERATION (continued)
Carry
Handle
Power Head
Assembly
Dust Drum
WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a Blower.
WARNING: To reduce the risk of
injury to bystanders, keep them
clear of blowing debris.
CAUTION: Wear a dust mask if
blowing creates dust which might
be inhaled.
CAUTION: To reduce the risk of
hearing damage, wear ear protectors
when using the Vac/Blower for
extended time or in a noisy area.
Blowing
Port
Hose
11