Important - THOMSON 512391 Manual De Instrucciones

Ocultar thumbs Ver también para 512391:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 78
d - CONFigurATiON
5 Connection required: indicates whether
connection is compulsory (authentication)
to send an email. In our example
using gmail: Yes (in other words: you cannot
send an email via gmail
if you are not logged into your account).
6
SMTP user name: Name you need to enter
to connect to the mailbox which will send
the alerts. In our example using gmail, this
is the sender address: sender-address@
gmail.com
7
SMTP password: The password
used to log into sender-address@gmail.com
in our example
8
E mail sender: Re-enter the address used
to send the alerts: sender-address@gmail.
com. Click on 'Test' to check that your
settings are correct and that the camera is
able to connect to the email account you
entered for sending the alerts.
9
First addressee, etc.: Use this space to
enter the address or addresses which will
receive the alerts. In our example:
addressee@gmail.com
10
IMPORTANT: When you have finished
configuring the device, do not forget to click
on 'Sauver [Save]' at the top of the screen
to confirm the entries you have made.
Note: it does not matter who the email provider of the
addressee or addressees is as it is the email provider
of the sender which dictates what needs to be entered.
However, you must ensure you check that the alerts
are not treated as spam by any of the addressees.
• When you have finished configuring your camera,
it will be able to send emails. You must now tell
it when to send them by clicking on 'Alarme
[Alarm]', 'Détection de mouvement [Motion
detection]':
1
10
en
2 3 4 5
6 7
720p WiFi Fixed ip Hd camera
1
Tick the 'Activer [Enable]' box to enable
motion detection
2
Sensitivity: At the 'haute [high]' setting,
even the smallest movements on the
screen will set off an alert At the 'basse [low]'
setting, only large subjects will set off an alert
(for example: a human being, but not a dead
leaf in the camera's field of vision). Adjust to
suit the camera's field of vision and
the desired objective.
3
Pause trigger: pause between alerts if
motion is detected over an extended period
4
Tick 'envoyer e-mail [send email]' on alert
5
Detection zone: when you click this button,
a grid is superimposed on the camera image.
If motion is detected in a red box, an alert is
triggered. If motion is detected in a clear box,
no alert is triggered. Click on the boxes to
change their status from enabled (red) to
disabled (clear), e.g. to avoid monitoring a
window pane and setting off an unnecessary
alert because of something going on outside.
6 This grid shows which half-hourly periods
in the week motion detection should be
enabled. Click on one of the boxes to enable
detection during the corresponding half-hour
period. You can also click on the a day of the
week or a time to enable an entire row or
column. To enable 24/7/365, click on
'Tous [All]'. Red boxes indicate that
detection is enabled.
7
IMPORTANT: When you have finished
configuring the device, do not forget to click
on 'Enregister [Save]' at the top of the screen
to confirm the entries you have made.
This completes the configuration. From now on, any
motion detected by the camera in the zones and at
the times you have specified will trigger an email alert.

Publicidad

Tabla de contenido
loading

Tabla de contenido