Listo RLIL 125-55b1 Instrucciones De Uso página 21

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

refrigerator.
The appliance must not be exposed to direct sunlight.
The appliance must not be exposed to rain.
The appliance must not be installed next to a radiator, a stove or any other heat
source.
The appliance's energy consumption and efficient operation are affected by
the ambient temperature.
The installation of the appliance must not obstruct the power point.
After installation, make sure that it is not resting on its power cord.
Leave the appliance in its final location for two hours before plugging it in to
allow the refrigerant circuit to stabilise.
C
limate Class
Only install the appliance in a location where the room temperature matches the
climate class for which it was designed (see table below).
The climate class is on the rating plate located on the outside of the appliance.
The table below shows the correct room temperature for each climate class:
Climate class
Your appliance is rated "N". If the room temperature is below or above the indicated
room temperature, the performance of your refrigerator may be affected, and your
food may spoil.
s
uffiCieNt VeNtilatioN
To ensure the proper operation of your appliance, ensure that air can circulate
freely around the unit. If you wish to place the appliance in a recess or directly
underneath a unit, it is essential that you leave a space of 10 cm between the top
of the appliance and the top unit.
If this is not possible, leave 5 cm between the top of the appliance and any other
kitchen furniture attached to the wall, and a gap of 2.5 cm on each side of the
appliance.
If your appliance is to be installed next to another refrigerator or freezer, make
sure the appliances are not touching each other. This is to prevent condensation
from forming on the outside.
SN
N
ST
T
Room temperature
+10 to +32°C
+16 to +32°C
+16 to +38°C
+16 to +43°C
21
V.1.0

Publicidad

Tabla de contenido
loading

Tabla de contenido