Adam Equipment GBK Serie Manual De Instrucciones página 57

EN
Apply power to the indicator. If the jumper has been used the display will ask for a
code number, "Pn " on the Weight Display immediately.
during the time the calibration counters are being displayed.
Enter the number 1000 when "Pn " is displayed and then press [Tare].
The displays will show the first parameters, called "F4" "Int".
To select another parameter press the [Func] key to advance through the
parameters.
Press the [Tare] key to enter a parameter.
To exit a parameter, press the [Zero] key.
The display will show the parameter number and a name.
When a parameter is entered by pressing the [Tare] key, the displays will guide you
through the parameter selected and the options available.
The parameters available are:
"F4 Int"
"F5 rEZ"
"F6 SCS"
"F7 Cnt"
"F8 Zem"
"F9 Lvd"
"F10 Cn"
"F10 Az"
© Adam Equipment Company 2011
Initial Zero Range
Re-Zero range
Successive Tare Enable
Display the A/D counts
Zero Mode
Low voltage detection
GK-M only, Calibration and Parameter counters or
Auto Zero Range
55
Or press the [Tare] key
3056610542RevD-Aug11