Adam Equipment GBK Serie Manual De Instrucciones página 58

EN
F4 –INITIAL ZERO RANGE
To enter this parameter, press the [Tare] key when "F4 int" is shown.
The display will show the current initial zero range.
Press the [Func] key to change the value and press [Tare] to accept the value.
Press [Zero] to return to weighing.
F5 -RE-ZERO RANGE
To enter this parameter, press the [Tare] key when "F5 rEZ" is shown.
The display will show the current re-zero range.
Press the [Func] key to change the value.
Press [Tare] to accept the value.
Press [Zero] to return to weighing.
F6 -SUCCESSIVE TARE
To enter this parameter, press the [Tare] key when "F6 SCS" is shown.
The display will show if the successive tare is on or off.
Press the [Func] key to change the value.
Press [Tare] to accept the displayed value.
Press [Zero] to return to weighing.
F7 –ADC COUNTS
To enter this parameter, press the [Tare] key when "F7 Cnt" is shown.
This parameter allows you to view the A/D counts from the internal A/D converter.
This can be an aid to service.
Press the [Tare] key to return to the PARAMETER menu.
Press the [Zero] key to return to weighing.
Typical value at zero is 30,000-90,000 (approx.)
Typical value at full capacity is 500,000 (approx.)
© Adam Equipment Company 2011 56 3056610542RevD-Aug11