Shoulder Strap; Important; Operating - Oreck XL COMPACT CANISTER VACUUMS Guia Del Usuario

To Operate
IMPORTANT: DO NOT REMOVE
the dirt retaining flap attached on the
back of the front plate. It must be left in
place for the unit to operate properly
and to ensure cleaning effectiveness.
ON/OFF
Switch

Shoulder Strap

Insert end of shoulder strap into slot in
front of on/off power switch. Pull
through three to four inches and insert
into plastic clip. One inch of strap
must be completely through clip. Insert
other end of strap through slot located
at back of handle. Insert end into clip
and pull through. Adjust length by
pulling strap through clip. Strap must
go through both front and back clips.
IMPORTANT: Before using shoulder
strap, pull both ends to be sure it is
secure.
E N G L
Strap Slot
4
I S H
Hose & Tool Installation
The flexible hose uses a Shurlok
locking system that prevents hose
removal unless intended. To install
hose, align "J" slot in hose coupling
with tab inside the suction port. Insert
hose in port. Twist collar clockwise to
lock hose coulping in port. Twist
counterclockwise and pull to remove
hose.
Adapter Tube
The extension wands and cleaning
tools supplied with your Oreck XL
Compact Cannister Vacuum lock
together with friction. Twist and
push to be sure they lock tightly
when installing. Twist and pull to
remove.
When installing tools directly to
blower or suction port without using
hose, tool adapter must be used.
Twist and Push to
install tools.
Twist and pull to
remove tools.
®