Configuring - wtw Cond 330i Instrucciones De Operación

Configuring

Baud
4 0 8
1 n T 3
Time
d 1 8
A r n
Y
E
t 2 5
Tref25
S/
o d
C n
0 0 9
Day.Month
10
Configuring
Note
You can leave the configuration menu at any time with <M>. The parameters
already changed are stored.
Procedure for configuring (factory settings appear in bold typeface):
l Switch off the measuring instrument.
l While pressing the <M> key, press <
l Select the required Baud rate with < > < >.
0
Selection: 1200, 2400, 4800, 9600 Baud.
l Then press the <RUN/ENTER> key.
l Set the required calibration interval with < > < >.
Selection: 1... 180... 999 d.
l Then press the <RUN/ENTER> key.
0
l Switch the automatic measuring range selection AutoRange on/off with
< > < >.
Selection: YES (On), no (Off).
l Then press the <RUN/ENTER> key.
S
ARng
l Switchover the reference temperature of the conductivity with < > < >.
Selection: 25 °C (Tref25) and 20 °C (Tref20).
l Then press the <RUN/ENTER> key.
l Switch the units of the conductivity display on/off with < > < >.
Selection: S/cm, M Ω
cm
l Then press the <RUN/ENTER> key.
l Select the date and time step-by-step with < > < >. In between, press
4
the <RUN/ENTER> key each time.
l When the last <RUN/ENTER> key has been pressed, the instrument
changes to the last active measuring mode.
>.
⋅
cm.
Cond 330i/340i