WEG Anybus-CC Guía De Instalación, Configuración Y Operación página 4

For correct installation of the communication modules, follow the steps below:
Step  With the drive de-energized, remove the front cover of the CFW-11
(figure 2).
Step  With the help of pliers, remove the fins located in the lower part of the drive.
(figure 3(a)).
Step 3 Carefully insert the module in slot 4. To do this, gently press the Anybus-CC
module against the control card of the drive and slide it in the direction of
the connector, observing the fit through the opening in the plastic cover of
the control card (figure 3(b)).
Step 4 Make sure that the entire base of the Anybus-CC is in contact with the control
card, and that the module locks are properly inserted in the borders of the
card (figure 3(c)).
Step 5 Tighten the screws of the module using the supplied torx screwdriver
(figure 3(d)).

a
Figure 2: Removal of front cover
a
Figure 3: Accessory installation in the slot
b
c
b