Honeywell CL30XC Manual De Uso página 5

USE & OPERATION (CONTINUED)
CLEANING & DRAINING THE WATER TANK (CONTINUED)
Refill the water tank with clean water, up to the maximum level.
Replace the top of the air cooler carefully back onto the tank and lock the side latches. The air cooler
is now ready to be used.
Use a damp cloth to remove dirt and dust from the surface of the unit. Never use corrosive elements
or chemicals to clean this product.
When the product is not in use, store the unit in a dry place out of direct sunlight.
CLEANING THE CARBON DUST FILTER* AND HONEYCOMB COOLING MEDIA
The appliance is supplied with a Carbon Dust Filter* &
Honeycomb Cooling Media.
The Carbon Dust Filter* and Honeycomb Cooling Media are
located inside the Rear Grill. See Figure 1 for instructions on
how to remove them from the unit for cleaning and
maintenance.
Do not run the unit in COOL mode with stale water in the
tank. You must empty the water tank and refill with fresh
water, especially if the tank has not been cleaned in a long
time.
The cleaning frequency for the Honeycomb media depends
on local air and water conditions. In areas where the mineral
content of water is high, mineral deposits may build up on the
Honeycomb Cooling Media and restrict air flow. Draining the
water tank and refilling with fresh water at least once a week
will help reduce mineral deposits. If mineral deposits remain
on the Honeycomb Cooling Media, the media should be
removed and washed under fresh water. The media should
be cleaned every two months or sooner, depending on your
needs.
For best results allow the Honeycomb Cooling Media to dry
after each use by turning off the cool function 15 minutes
before turning the unit off.
Figure 1:
Removing the Carbon Dust Filter*/ Honeycomb Cooling Media:
1. Remove all the screws from the Rear Grill of the Air
Cooler.
2. Carefully pull out the rear grill from the cooler.
3. Slide out the Carbon Dust Filter* and clean with water.
4. The Honeycomb Cooling Media is secured on the
Honeycomb Frame by a Horizontal Bar that is fixed in
place by two screws. Remove these two screws to
release the Horizontal Bar and slide the Honeycomb out
of the frame.
5. Replace or clean media with water and a damp cloth as
needed.
WARNING: DO NOT operate the Air Cooler when the
Rear Grill or Honeycomb Frame is removed from the Air
Cooler, or if there is a loose-fitting Rear Grill or
Honeycomb Frame. Doing so can cause serious injury or
dangerous electrical shock.
*Applicable for models with Carbon Dust Filter only.
EN 4
Honeycomb
Cooling Media
Carbon Dust
Rear Grill
Filter
Honeycomb Horizontal Bar
Frame