Philips Pronto TSU9200/00 Manual De Inicio página 11

Downloading the Configuration to the Remote Control
As a last step in the wizard, the configuration needs to be downloaded to the Remote
Control.
To download the Configuration to the Remote Control:
Connect the Remote Control to the PC with the USB cable.
1
The Remote Control goes into test/download mode. In this mode the Remote Control
cannot be used, it can only be controlled by the PC editor.
Click Download to Remote to start downloading.
2
The editor will not allow further modifications until the download is complete.
This normally takes 15-30 seconds.
Follow further instructions on the PC screen.
3
D Note
Click Print Summary to print a list of the configured components and the way they are
connected to the RF extenders.
B Warnings
Do not pull the USB cable out of the PC when you are downloading the configuration.
Messages regarding the download appear
in the Configuration Program.
Configuring the Pronto Remote Control
11