Washing Instructions - Sunbeam FlexTemp 901-825 Manual De Instrucciones

AUTO-OFF FEATURE
Your heating pad controller includes an Auto-Off feature. This feature is designed for
convenience and to conserve energy by automatically turning off after 2 hours of continuous
use. The Auto-Off Indicator (Figure 5, letter C) will flash when the auto-off feature is activated
and the pad shuts off. To restart, press the Control Button until the desired heat setting is
reached.
NOTE: After a power outage, the Auto-Off feature automatically resets the timer.
HOW TO USE YOUR JOINT WRAP FOR COLD THERAPY
– SEE FIGURE 6
1. Place Gel Pack (Figure 1, number 9) in the
freezer for at least 1.5 hours prior to use.
2. Disconnect controller from the pad by
pushing down on the Connector Release
Tab (Figure 4, letter C) and pulling the Cord
Connector (Figure 4, letter A) away from the
Pad Connector (Figure 4, letter B).
Note: Heat therapy should never be applied
while the gel pack is in use.
3. Once gel pack is cold, insert into the Mesh
Gel Pack Pouch (Figure 1, number 3) and
secure in place with the Gel Pack Pouch
Fastener (Figure 1, number 4).
Note: Always use product with the provided
cover. Never apply directly to skin.
4. Apply wrap to the elbow or knee using the application instructions.
FlexTemp Joint Wrap 901-825_19ESM1 (US).indd 9-10
Figure 6
-
-9
STORAGE INSTRUCTIONS – SEE FIGURE 7
When FlexTemp Hot + Cold Joint Wrap is not in use, easily
TM
store away until next treatment.
1. When not in use, the Gel Pack can be stored in the Mesh
Gel Pack Pouch.
Note: For increased shelf life, store Gel Pack in cool, dry,
and ventilated area away from incompatible substances.
Keep away from sources of ignition. Do not store in
freezer.
2. Neatly wrap cord and controller and place inside the
Fabric Sleeve. Tightly wrap Elastic Fastening Straps
around the pad and secure for compact, clean storage.

WASHING INSTRUCTIONS

CAUTION: DO NOT DRY CLEAN! DO NOT BLEACH! DO NOT USE
WRINGER!
1. Disconnect pad from outlet. DO NOT PULL BY THE CORD.
2. Disconnect Controller Cord from pad by pressing the tab
on the Cord Side Connector and pulling on the Pad Side
Connector.
3. Fold Elastic Fastening Straps and attach Strap Hook Fasteners to the Exterior Pad Fabric
before placing in the washing machine.
4. Machine wash pad in cold water on gentle cycle or hand wash. Tumble dry on low heat
and remove promptly from dryer or drape to dry.
5. DO NOT plug in pad and pad connector until completely dry.
6. DO NOT wash with the Gel Pack inserted.
7. DO NOT iron your heating pad.
8. For information on service, visit our website at www.sunbeam.com.
Figure 7
-10-
3/25/19 9:48 AM