Valore VS1205 Guía De Instalación Del Usuario página 12

This section will help you measure the
required length of the Main PVC Supply Line
(Part 8) relative to the final position of the
Template Guide
Steps:
• Measure the distance between the bottom of
the template to the closest approximate hole
position on the top of the template which
corresponds to where the shower outlet pipe
is. Refer to this distance as "d1".
• Add 1 inch to your "d1" measurement.
• Using the length of "d1" as a guide, measure
this length on the Main PVC Supply Line Hose
(Part 8) and shear the excess length from the
hose.
Connecting the elbow connector assembly to
the main PVC supply line:
• Insert top-end of Main PVC Supply Line (Part 8)
into the Chrome Compression Nut (Part 7).
• Insert Part 3 into combination of 7/8 and
tighten in a clockwise turn motion while gently
but firmly pushing downwards until the main
PVC supply line is properly connected to the
elbow connector valve with o-ring gasket and
chrome compression nut is in between.
English
INSTALLATION
Draw a level horizontal line based on
5
the lower-edge of the selected hole
6
7
8
12
3
3
7
8
8
Shear