Valore VS1205 Guía De Instalación Del Usuario página 18

• After all connections have been completed on
the rear of the shower panel, it is ready to be
hung unto the shower wall for permanent
installation.
• Simply raise the shower panel and bring close
to the surface of the shower wall and gently
lower it until the bracket support struts
pre-welded at the back of the shower panel
meet the Positioning & Support Brackets
installed in step 10. Please ensure the middle
part of the brackets (Part 14) are centered to
the middle part of the bracket support struts
which have a cut-out section to lock in the
brackets.
• Once a snug and secure fit is achieved and all
parts of the PVC Supply Line are secured to the
back of the shower panel, silicone sealant can
be applied to the rear of the shower panel
casing to hold it in place and prevent water
from entering the rear of the panel.
a. Peel off the adhesive paper from the back of
the Base Plate Cover (Part 5)
b. Position the flat side of Part 5 with adhesive
facing the shower wall and apply pressure to
secure it.
Note: Please make sure this surface is free
from dirt and residue to ensure the adhesive
bonds with the wall. If the existing shower
pipe outlet does not protrude from the wall,
then there is no need to apply the Base Plate
Cover (Part 5) and the Shower Head Outlet
Connection Cover (Part 2)
c. Join the Elbow Connector/Main PVC Pipe
assembly to the Brass Extender Joint (Part 4) by
connecting them and turning clockwise to tighten
(do not over-tighten).
d. Install the Shower Head Connector Cover
(Part 2).
Congratulations! You have completed
installation of your new Valore shower panel!
We hope you enjoy using your new shower
panel for many years to come! If you have
questions, comments or need assistance,
please contact us using the information on
the next page. Thank you!
English
INSTALLATION
12
13
a.
c.
18
14
14
b.
5
d.
4
3
8
4
5
2
8