Dometic WAECO PerfectView CAM33C Instrucciones De Montaje Y Uso página 32

_CAM33.book Seite 32 Freitag, 20. Mai 2011 11:40 11
Safety and installation instructions
Please observe the following instructions:
 To prevent short circuits, always disconnect the negative terminal of the
vehicle's electrical system before working on it.
If the vehicle has an additional battery, its negative terminal should also
be disconnected.
 Insufficient supply line connections could result in short circuits which
– Cause cable fires
– Trigger the airbags
– Damage electronic control devices
– Cause electric functions to fail (indicators, brake light, horn, ignition,
lights)
 When working on the following cables, only use insulated cable terminals,
plugs and flat push-on receptacles:
– 30 (direct supply from positive battery terminal)
– 15 (connected positive terminal, behind the battery)
– 31 (return cable from the battery, earth)
– 58 (reversing light)
Do not use terminal strips.
 Use a crimping tool (fig. 1 10, page 3) to connect the cables.
 Screw the cable for connections to cable 31 (earth)
– Screw on the cable using a cable terminal and serrated washer to one
of the vehicle's earth bolts or
– Screw the cable to the bodywork using a cable terminal and a self-tap-
ping screw
Make sure there is a good earth connection.
If you disconnect the negative terminal of the battery, the entire data stored
in the volatile memories will be lost.
 The following data must be reset, depending on the vehicle equipment op-
tions:
– Radio code
– Vehicle clock
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the corresponding
operating manual.
32
PerfectView CAM33
EN