Dometic WAECO PerfectView CAM33C Instrucciones De Montaje Y Uso página 38

_CAM33.book Seite 38 Freitag, 20. Mai 2011 11:40 11
Notes on the electrical connections
Please therefore observe the following instructions:
 As far as possible, use original openings or alternative openings for the
connecting cable duct, e.g. the paneling edges, ventilation grilles or blank
panels. If no openings are available, you must drill holes for the cables.
Check beforehand that there is sufficient room for the drill head to come
out on the other side.
 Wherever possible, lay cables inside the vehicle, as they are better pro-
tected there than outside.
If you do need to lay a cable outside the vehicle, ensure that it is well fas-
tened (use additional cable ties, insulating tape etc.).
 To prevent damage to the cables, when laying them, ensure that they are
far enough away from hot or moving vehicle components (exhaust pipes,
drive shafts, light systems, fans, heater etc.). Use corrugated piping or
other protective materials to protect against mechanical wear.
 Screw on the plug connections of the connecting cables to protect against
water penetration (fig. c, page 7).
 When laying the cables, make sure:
– They are not kinked or twisted
– They do not rub on edges
– They are not laid through sharp-edged ducts without protection
(fig. 3, page 4).
 Attach the cables securely in the vehicles to prevent tripping hazards. Use
cable binders, insulating tape or glue the cables in place.
 Protect every through-hole made in the bodywork against water penetra-
tion, e.g. by using a cable with a sealant and by spraying the cable and
the the cable sleeve with sealant.
I
NOTE
Only start sealing through-holes when you have completed all in-
stallation work on the camera and have laid the required cable
lengths.
38
PerfectView CAM33
EN