Technibel KPSW 2 Manual De Instalación página 15

C
Make a Ø 80mm hole, as required.
E
Open a pre-punched hole for the
pipe passage (work from outside).
Fit the seal delivered with the device
around the edge of the hole used for the cable
feed-through (cable protection).
G
Fit the unit's fi xing rods.
Use rawl plugs suitable to the wall
consistence and four threaded bars
of suitable length.
I
5 - 10 mm
Provide gravity drainage of these condensate
while respecting the slope.
Remove the cover located at the bottom of the suction
grille in order to put the condensate pipe through.
See connection details in paragraph 4.
K
Fix both the side panels
and reassemble the return
air grille.
D
5 / 10 mm
Remove the return air grille releasing it from the side guides
and the central elastic stop.
F
Fix the side brackets
by means of the bolts supplied in the kit.
H
35 - 45 mm
Fix the unit to the ceiling
(use the square spacers).
Make sure that the assembly is well-fi xed.
J
Cover
according to the indications given in paragraph 4.
Carry out
the electrical and hydraulic connections
GB
6