Dometic WAECO MagicSafe MS660 Instrucciones De Montaje Y De Uso página 72

_MS660.book Seite 72 Montag, 2. August 2010 8:03 20
Connecting the power to MagicSafe
7.2 Connecting the connection cable to the control unit
➤ Insert the plug of the connection cable into the corresponding connection
on the control unit
7.3 Connecting the connection cables of the 15-pole
plug
Black (P1)
This cable is the antenna and does not have to be connected.
➤ Lay the antenna at an interval of at least 1 cm to metallic parts
Red (P2)
➤ Connect this cable to a cable with a permanent +12 volt charge
(terminal 30).
White/black (P3)
➤ Connect this cable to the left indicator cable of the vehicle.
Black/green (P4)
➤ Connect this cable to the right indicator cable of the vehicle.
Green/yellow (P5) and green (P19),
factory-set as a starter circuit breaker
These cables can break any electrical circuit (e. g. fuel pump, starter etc.).
The output (green/yellow) can be charged with a maximum of 10 A.
➤ Disconnect the cable from the consumer (fig. 0 1, page 5) to earth
(fig. 0 A, page 5) or to the battery (fig. 0 B, page 5).
➤ Connect the green cable and the green/yellow cable in accordance with
fig. 0, page 5.
Alternatively, siren MS-620SI or the vehicle horn can be connected to the
green/yellow (P5) cable (see software functions no. 13 and no. 9).
72
MagicSafe MS660