Blender Safety - Hamilton Beach Proctor Silex 55000 Manual De Operación

Blender Safety

IMPORTANT: This operation manual should be reviewed with all equipment operators as part of your
operator training program.
IMPORTANT SAFETY INSTRUCTIONS
WARNING –
When using electrical appliances, basic safety precautions should always
be followed to reduce the risk of fire, electric shock, and/or injury to persons, including the
following:
1. Read the Operation Manual before using
blender. Keep Operation Manual handy.
2. Before first use, wash container assembly
in hot, soapy water. Do NOT place in
dishwasher.
3. Plug into a grounded outlet.
4. Do not remove ground.
5. Do not use an adapter.
6. Do not use an extension cord.
7. Disconnect power before cleaning or
servicing.
8. To reduce risk of personal injury, unplug
cord from outlet when not in use and
before putting on or taking off parts.
9. Unplug the blender and inspect the power
cord insulation for cracks on a weekly
basis. Refer to "Technical Services" for
repair or replacement.
10. To protect against electrical shock, do not
immerse cord, plug, or blender base in
water or any other liquid.
11. Do not spray the base with a high-
pressure spray gun.
12. Extreme caution must be used when
moving an appliance containing hot oil or
other hot liquids.
13. Do not use appliance for other than
intended use.
14. Not intended for use by or near children.
Children should be supervised to ensure
that they do not play with the appliance.
15. The appliance is not intended for use by
persons (including children) with reduced
physical, sensory, or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision
or instruction concerning use of the
appliance by a person responsible for
their safety.
16. The use of accessory attachments
not recommended by the appliance
manufacturer may cause injuries.
17. To reduce risk of personal injury and to
prevent damage to blender or container
and cutter assembly, DO NOT insert
utensils into blender container while
operating blender.
2
18. Do not store any kitchen utensils in the
container because the blender would be
damaged if inadvertently turned on.
19. To prevent possibility of serious personal
injury, keep hands out of blender
container while operating blender.
20. Avoid contacting moving parts. Switch
OFF ( ) the appliance and disconnect
from power supply before changing
accessories or approaching parts that
move in use.
21. Blades are sharp. Handle carefully.
22. If cutter assembly blades are loose,
discontinue use immediately and replace
cutter assembly. Do not attempt to repair
or tighten blades.
23. Inspect container and cutter assembly
daily. Do not use broken, chipped, or
cracked container. Check cutter for wear,
nicks, or broken blades. Do not use
broken or cracked cutting blades.
24. Do not use outdoors.
25. This appliance is intended for short
periods of operation, with a rated
operating time of 3 minutes.
26. Do not leave blender unattended while it
is operating.
27. To prevent damage to blender, container,
or cutter assembly, DO NOT move or
shake blender while in operation. If
blending action stops during operation,
turn blender OFF ( ), remove container
from base, remove container cover, and
use a thin rubber spatula to push mixture
towards cutters.
28. When blending hot liquids, remove
center piece of two-piece lid. Hot liquids
may push lid off jar during blending. To
prevent possible burns: Do not fill blender
jar beyond the 1 quart (946 ml) level.
With the protection of an oven mitt or
thick towel, place one hand on top of lid.
Keep exposed skin away from lid. Start
blending at lowest speed.
29. Be careful if hot liquid is poured into the
blender as it can be ejected out of the
appliance due to sudden steaming.