Loose Parts; Assembling The Blower; Product Overview - Toro Flex-Force Power System Manual De Instrucciones

Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.
Description
Blower tube
Note:
The battery pack is not fully charged when you purchase it. Before using the tool for the first time, refer
to Charging the Battery Pack (page

Assembling the Blower

Slide the blower tube onto the blower housing. You
may need to press down on the tube latch for the
blower tube to lock into place
1. Tube latch
7).
(Figure 1).
Figure 1
Qty.
1 Assemble the blower.

Product Overview

Specifications
Appropriate Temperature Ranges
Charge/ store the battery pack
at
Use the battery pack at
Use the blower at
Store the blower at
g273147
*Charging time will increase if you do not charge the
battery within this range.
Store the tool, battery pack, and battery charger in an
enclosed clean, dry area.
5
Use
5°C (41°F) to 40°C (104°F)*
-30°C (-22°F) to 49°C (120°F)
0°C (32°F) to 49°C (120°F)
0°C (32°F) to 49°C (120°F)*